BoaterEd Store      - Help Support This Forum - Join Today!      Hunting/Fishing Stuff
BoaterEd
Username:
Password:
Save Password


Register

Active Topics | Active Polls | Resources | Members | Online Users | Avatar Legend | Statistics
[ Active Members: 5 | Guests: 181 ]  [ Total: 186 ]  [ Newest Member: colrhino ]
 All Forums
 Clubs - Organized Clubs, Cruises and Activities
 Regal Owners
 Getting behind the steering wheel area (2000 2460)

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

 Posting Form
Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker Insert Smilie
   
Callouts: Insert Speech Icon: duh! Insert Speech Icon: oops! Insert Speech Icon: sigh! Insert Speech Icon: ugh! Insert Speech Icon: wow! Insert Speech Icon: yeah! Insert Speech Icon: ok! Insert Speech Icon: yes! Insert Speech Icon: no!
Message Icon:              
             



   -  HTML is OFF | Forum Code is ON
   
 
  Check here to include your profile signature.
Check here to subscribe to this topic.
    

T O P I C    R E V I E W
Ikhanton Posted - Jun 15 2011 : 09:21:38
I am trying to get behind the steering wheel area(2000 2460) to install a auto trim tab sys. Has anyone opened up this area and explain to me how that worked?

5   L A T E S T    R E P L I E S    (Newest First)
Ikhanton Posted - Jun 19 2011 : 20:17:27
FYI to all,

If you need to access the area or electronics/wiring behind the steering wheel, do so by opening up the switch panel is a great way for access.

Also, installing a Auto Trim Tab (AC3000) was a easy/great install.
KiDa Posted - Jun 15 2011 : 19:09:42
The screws around the perimeter of the gauge cluster hold it in place. Ditto the switch panel. Ditto the trim tab switch. There is plenty of room back there, but not a lot of extra wire. There is enough to get it out of the way. They did a far better job than most in that arena.

I looked at that setup. Before you tear into the dash, check the placement parameters. When I looked at this 5 years ago, the recommended location was as close to midships as possible which would put it somewhere in the aft cabin. A lot has changed in microchip technology in 5 years though.

Maybe Tabman will chime in.

BTW, depending on your engine and that Navman unit, you may be able to get diagnostic information from the engine sent to that screen.
CurrentSea Posted - Jun 15 2011 : 11:53:59
Call Regal, quick check on the schematic and they will know.
Usually panel under comes off or the whole dashboard unscrews.
Most boats usually the dashboard unscrews.
Ikhanton Posted - Jun 15 2011 : 11:11:44
I have purchased a auto trim tab system, it is a gryoscope. It plugs into the existing Bennett trim tab switches allowing me to have it auto balance the boat while on-plane.

I figured that the best place to install the box was close to where the trim switches are, and in my case behind the steering wheel area.
KiDa Posted - Jun 15 2011 : 11:07:34
I used to own a 2001 246X. What exactly are you trying to put where?

BoaterEd © BoaterEd Go To Top Of Page
This page took 0.38 seconds to load
Forum Guidelines and Privacy Notice

    

Boatered.com