Raymarine fish finder

B

BillyK

Active member
Member
Joined
Dec 6, 2006
RO Number
24466
Messages
1,146
Raymarine%20plug_zpszuitnybz.jpg
[/URL]

This is the unit end of a transducer cord that used to go with a Raymarine L760 plus GPS. The 760 is no longer operational but I think the transducer is. I know this is an older model, but does anyone have knowledge as to if it would fit a newer fish finder/sonar?

Thanks,

Billy k.
 
Bill: I wish I could help but that is such a specialized question that you might get better answers from Raymarine tech support.
 
Most transducers are made by airmar, the only variation for each electronic manufacture is the connector. I just replaced the xducer on charmer as it failed (worked fine in deeper water, 11/12' or deeper but not shallow. It's just two signal wires plus a ground/shield. Spliced it in and done
 
There is a module available that will take most airmar transducers and convert to NMEA 2000. Works great.
 
Thanks guys for the help. Does it say somewhere the manufacturer? I think I will try tech support before I cut out the connector. Rommer, do you have a link for that module?

Thanks again,

Billy K.
 
verify with tech support but I believe this cable will allow use of your transducer on all the new units.

Raymarine Transducer Adapter Cable f/DSM30 & DSM300

Part Number:E66066-RAY
 
You must log in or register to reply here.
Back
Top