Replacing a Shifter

BombayBlue

Member
Joined
Nov 5, 2005
RO Number
19472
Messages
29
Hi,

I have a 22' 87 Grady White OB with a 200 Mercury. I purchased the boat last spring and went through one summer with it.

The shifter is stiff and it takes more effort than I would like to push it to the side to put it in neutral. Froward and reverse is fine. It looks like it is the original equipment on the boat. I sprayed penetrating oil and WD40 both from above and below a few times last summer. It loosend up a bit but is still stiff to push to the side for neutral. I'm afraid it's not going to go into neutral at a time I need it to.

My guess is that my summer project is going to be to replace it. Are there any lessons learned that I can benifit from?

Many Thanks --
 
if the cables have corrosion in them you can pull them off, clamp a tube over the casing fill it with oil and then clamp a schrader valve on the end of the tube and pump it up slowing with air. it will force the oil down the length of the cable.
 
You may be able to disassemble and grease and maybe replace a nylon bushing or two.
 
Bombayblue,

First you need to determine if it is the shifter or the cables. I had the same problem with my i/o. The the netrual only button went belly up. I asked my mechanic if he could fix it. He said, I can but I won't! The can be repaired, but the just fail again somewhere else, he had me replace it. It took about 2 hours, and not to hard of a job.
 
Back
Top