Spring Commissioning

Irishstorm

Member
exMember
Joined
Feb 11, 2006
RO Number
20208
Messages
35
I went to the boat yard to check on the work that was done for the spring commisioning. The boat looked great. All shined up and neat paint job. I have a concern about the paint job that was done. While it was nice and neat, they painted everything under the water line. Props, rudder, shafts, intakes, trandsducer etc. Is this OK or should this stuff be left alone.
 
The way I understand it, no paint on the water intakes or the tranducers.
Have a good season.
Ron
 
Definitely not the bottom of any transducer. Yes to the rudders and H2O intakes as long as H2O is not impeded; depends on the yard and/or owners propensity as to painting props and shafts. Some say yes; some no. On the shafts, there must be some area for zinc to shaft contact w/o paint interference.
 
...and make sure you boat was properly blocked!
 
I have never painted the props or shafts, always painted the rudders and the intake grills (don't block it!) otherwise you risk growth blocking the intakes. I installed a transducer a couple of weeks ago and the Airmar instructions say you MUST apply anti-fouling paint to the transducer but it has to be water based -- might not apply to all transducers but.... Hope this is helpful,

Tim
 
This shows you how old I am. H2O based bottom paint? Painting the bottom of the transducer? What will they think of next? Maybe an electronic device that shows objects in the fog?
 
The only thing I see that might be amiss is the transducer.

Transducers must be painted, but with water-based anti-fouling paint. Solvent-based paint can damage the urethane and plastic face of a transducer. I stuff called MDR. Comes in a little bottle, with a brush attached to the cap.

If the yard used a water-based anti-fouling you're good to go.
 
Back
Top