engine hours

50 hours with a poor design or lousy maintenance may be worse than 1000 with excellent maintenance.
Boat engines not commercially used never wear out they die from lousy maintenance that usually shows up as rust or corrosion.
Find a boat with a clean bilge and no rust with an owner who can tell you in detail how he maintains it, then look at the meter.
 
On a boat, engine hours is a poor measure of quality.

An underused engine can be far worse than a well maintained older engine. As Bruce indicated, it is the "care and feeding" of the engine that matters, not the hours.

Of course, an engine -can- simply have too many hours, but I would not be concerned till well over 2000 hours. Keep in mind that there is no law related to hourmeters as there are for mileage an autos. You can change the hourmeter and/or setting at any time, for any reason. The only good reason for an hourmeter is to schedule the next maintenance.
 
I agree. I have seen many dead engines with 100 hours or less. I would be careful about buying a boat 5-7 years old with lless than 100 hours of use
 
It used to be that outboards were 1000 to 2000 hours longivity--in todays world we are hearing of 5,000 to 10,000 hours if properly kept in commercial operations (which means that they are run daily). For inboards--about the same--but most rust out or are upgraded before 1000 hours. The older low speed diesels--some were good for well over 20,000 or more. The Medium speed diesels were good for at least 5000, and often 10,000 hours. The modern high speed, with more than 1 hp per cubic inch maybe will need work by 1000 and probably a rebuild at 2000 hours. Again depends on how maintained and run.
 
Back
Top