GPS Help please

Audrey II

Active member
Member
Joined
Aug 5, 2008
RO Number
30499
Messages
6,405
I just received my new Garmin 4208 everything seems to work great on bench test however even though I updated my Mapsource software I can not get it to talk with my computer. I can transfer data using a SD card but, I used to just plug my laptop into a 9 pin serial cable that I installed on my last boat it made transferring data quick and easy it was also needed for enroute software to function. I install electrics systems for a living I'm no stranger to wiring. However I can't figure out the manual as far as the TX/A- and RX A+ I don't see any A- connections only B-. I have tried A+ on both port 1 and 2 but no luck. Tech support is only open the hours that I work so it's tough to get help at this time.

If anyone has any info it's much appreciated.
 
66 Reads and not a single reply looks like I'm on my own. I knew it was a long shot but figured it couldn't hurt to ask.
 
I would get in touch with Garmin's support staff. I've contacted them with a couple of issues(hardware problems, we found out later). They are very patient and very understanding. And.....they are GOOD!!! You will be taken care of in a professional, polite manner.
 
TX/A- and RX A+ is used in rs-422 standard. Serial port is rs232. Try to lower the speed of your serial port. There are different things you can try. They would be in the program your using to download the info. Changing the parity to odd, even or none, flow control from hardware to xon/xoff or none. Info for this should be in the garmin manual or website.
 
when using Mapsource the settings are all auto there are no settings to adjust I beleive there is a missprint the instructions. There is no A- in the first place only B- so I've tried just about all combos and still nothing I'll keep trying but Thanks. Any other ideas welcome.
 
Not sure if it applies to your setup but what is + to one device is - to the other.
 
Have you tried TX B(-) and RX A(+)? Does your computer do NMEA 0183? My old Garmin uses GRMN/GRMN interface with serial port.
 
I would say try your comm port settings and something in the back of my mind says you need to set the proper speed on your computer either 9600 or 36,400. I actually can't remember the upper speed it's around 36,400 or 38,600. Also go to the 4208's screen and tab over to communications you may have to enable that comm port as well. I wish I had my unit's installation guide I think you may find the answer there.
Bill
 
Well I got to the bottom of it I found a little time to call Garmin today and they told me that that the new models do not work the way the older ones do and that the 4208 can not talk to the Mapsource software the only way to transfer Data is by using a SD card. I must say I'm a bit surprised but as long as I can still pre-plan routes and print them out. I guess I can live with SD transfers.
You live and you learn
 
Back
Top