OK guys well I bit the bullit and the work is just about done. I had the marine pull boat power wash and replace anodes and touch up out drive. I stoped by the marina tonight and my boat was on the service dock I have a few questions.
1. I noticed the new paint looked a little bubbled on the top of the drive I am guessing this is probably because they put it in the water too soon? I will talke to them about that.
2. I noticed that my trim ram anodes where put on strang one is the normal way with the open end pointing down the othe is upside down (open end pointing up). any reason why they may have done this? is it ok like this?
1. I noticed the new paint looked a little bubbled on the top of the drive I am guessing this is probably because they put it in the water too soon? I will talke to them about that.
2. I noticed that my trim ram anodes where put on strang one is the normal way with the open end pointing down the othe is upside down (open end pointing up). any reason why they may have done this? is it ok like this?