Molding on swim platform

[WindDancer]

On my Sundancer 320, I have some plastic molding on that is fitted to the bottom of my swim platform that keeps falling off. Anyone know of a good adhesive that will hold plastic molding to metal? The area is below the water line.

Thanks
WindDancer

 

[TJackson]

I don't understand how there is metal on your swim platform or why it is below the water line, but either way, 5200 should work fine if you want it to be permanent.

 

[DS]

Get yourself some small stainless screws and put them on the back side of the moulding. Get them long enough to go thru the moulding and just bite lightly into the fiberglass. Place them about every two inches. I had a similar issue on my 240 SunDeck and that fixed it. This method also allows you to remove the moulding easily if you wanted to afterward.