Recently bought a Garelick flush mount unit and thought I could use a different pedestal which I had original to the boat as well as the table top . I used 5" bolts with washers and a 3/4" back plate . I need to buy the correct Garelick pedestal to fit properly into the plate but my question is with the table top . I would like to make one out of cherry in an oval measuring 32" x 16" . Has anyone done this before, is what I have done up to this step correct ? Do all pedestal tables give a little ?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Pedestal table
- Thread starter tagguy
- Start date
- Joined
- May 25, 2003
- RO Number
- 11591
- Messages
- 1,986
Out boat came with a Pedestal table and I took it out and replaced it with a table with legs. I found the Pedestal table was always in the way as it is a fixed unit. You could still make one from cherry in an oval measuring 32" x 16", but it doesn't have to be a Pedestal type.
There was a thread on here some time ago where someone posted pics of a table they had made and it was a nice looking table, but I cant find that thread.
There was a thread on here some time ago where someone posted pics of a table they had made and it was a nice looking table, but I cant find that thread.
- Joined
- May 25, 2003
- RO Number
- 11591
- Messages
- 1,986
single pedestal 30"...The table top was rectangle with rounded corners.
- Joined
- Jan 1, 2000
- RO Number
- 1702
- Messages
- 1,621
I built mine out of oak. I doubled it where the mounts meat and down the middle for stregth. the edge are single 3/4 thick. Coated it with West System Epoxy.