power problems...

justgotaboat

Member
Joined
Jun 18, 2009
RO Number
31427
Messages
159
I went to launch my sea ray 245 weekender the other day and I had totally dead batteries. It was my own fault (I think). I left the battery switch on for over three weeks, and I figure there is a slow draw from a few things even though everything was off. Once I got a jump the boat started up fine, and ran ok at a slow speed until I got out of the "no wake zone". Once there I tried give it some gas, but even with full throttle the boat could not come up onto plane. It could barely reach 3000 rpms and was way underpowered. The boat had 4 people, 4 peoples worth of camping gear for a few days, and a full tank of gas. In my opinion, not overloaded at all. It should have easily handled the load in it. But she definately could not handle it. I was under the impression that once an engine was running that it drew all its power needed from the alternator. Does having a bad charge on the batteries really affect the performance of the engine that badly?

Fearing the worst I took the boat to the local marina a few days later (the first available they had to look at it). The performance of the boat had gotten better over the course of the few days, but still seemed sluggish. Its got a 5.0L and a Bravo III. The mechanic took it for a ride and agreed that something was not 100%. He checked the timing, did a computer diognostic, made sure it had the right sized props, but came up with nothing. The boat can't seem to break 4200 RPMs completely empty and with only 2 people in it and seems sluggish coming up onto plane. What kind of RPM range should I be expecting out of this boat? The tach goes to 6000, so I figured somehwere just shy of 5000 would be realistic. Am I expecting too much out of my engine and outdrive? I was under the impression that the Bravo III was supposed to be more of a performance drive and therefore make the boat quicker. Am I out of line? Any help, thoughts, ideas, suggestions etc would be great. Thanks.

Remember, I did just get this boat, I am used to a mid 80's sea ray 225 with a 5.0L and an alpha one. So I contiually compare it to that.
 
How did the boat run when you sea trialed it before buying?
Remember, it's a much bigger and heavier boat that your 225 with the same engine. Stands to reason, you just will not get the same performance you did in your smaller boat.
 
Just a question from the peanut gallery; Could it be that your not going to get that big heavy boat up on plane without Trim tabs?
 
the battery shoudl be an issue since once it runs, the alternator is charging and powering everything. just realize that disacharging a battery greatly reduces its life expentancy, they never fully recover.

4 + a lot of gear is quite a bit expecially if the gear and pax are in the back. try putting the camping gear up front and sea if sending one person to the front, in the cabin will help.

4200 is on the low side but it's an old boat, if the engine has a lot of hours, it's not going to gibve you as new performance. did your guy check the compression?

i'd guess 4500 to 4800 should be the WOT RPM, not 6000

on small boats, it's all about weight distribution. trim tabs and possibly a Doelfin on the drive shoudl help.
 
Its a SeaRay, its gonna be a dog...

If the batteries are completely dead they will take a lot of tha alternators output and not leave much left for the rest of the house. I'd replace them.
 
What does the engine manual state WOT rpm should be. I'm thinking 4200 to 4600. If that's the case, you're on the low side of normal. I would think a 245 Searay with only a 5.0 l engine was underpowered from the factory. Four people plus full fuel and water and all the gear for four people is a lot of wt in a 24' boat. Like CWMS asks, is this a change in performance since the pre purchase seatrial?????
 
You never told us about your experience with this boat before this trip. Did it perform OK?

The batteries shouldn't have anything to do with it. The prop and timing didn't change by themselves during the three weeks you weren't using it.

As for being "overloaded, if you had a problem getting the boat on plane, you need to move some of the weight forward. Possibly some of the people, especially if they are "large" people. If you have tabs, put them down before you try to get on plane, then adjust them after you're on plane.
 
Agree, the boat is probably overloaded. As suggested weight forward will help, so will tabs. Bow down will get her up faster, but a V hull will not get up as fast as a flatter bottom.

You may want to load test the batteries. Running them flat does not do them any favors.
 
i had the load fairly evenly distributed... most of the gear up front, with 2 people in the back and 2 in the middle (none of which are "large"). I tried working the trim tabs, but it appeared to have little or no difference in terms of pickup or getting on plane (and yes they do work). I know that she is not going to run at 6000 rpms, but I was thinking that 4200 was on the lower end of what it should be. the sea trial and the few times we took her out she ran ok with 5 people, which is why I was scared by the drastic change in performance with just the added gear and gas.
 
Are you sure your trim tabs and are all the way down (as well as your outdrive) Weight (and wind) can make a HUGE difference. With my bridge enclosure zipped up tight, a brisk head-wind, full load of fuel, water and 2 or 3 guests, plus all the gear I have packed aboard, trim tabs down and both outdrives trimmed in, it seems to take forever, if ever, to get on plane. I agree with the experts, 6000 rpm sound way too high, possible wrong prop?
 
My tach will sometimes read over a 1000 rpm over where it should be, all it takes is a tap or two on the crystal and it falls back to the correct rpm reading.
 
Might it be possible like a car the computer needs to relearn itself? Just a thought I am not sure how volatile the memory is in a boat computer? Also it might be possible if the boat was sitting you have crud on the bottom causing additional drag? This should go away with a couple of high speed runs. I have trouble getting on plane in shallow water with my 40' gaser with 420hp 8.1Lhp's. I have V drives so the rear wants to suck down in shallow water and churn the bottom in my case under 5 feet. Generally after we reach 5 or more feet of water we have no problem getting on plane. My boat is very heavy fully loaded. I agree with the other comment above about wind and tide coming into play especially if you are right on the edge power wise. I have a hardtop and fully enclosed with the AC on we sometimes have problems with wind and tide but more with depth than anything else. Combine the 3 and I don't even try and labor the engines and just run at about 7 to 8 knots until we clear the shallow spots.
Bill
 
Bill, I think your point about being on the edge power wise is worth serious thought. A 5.0l engine in a 245 Searay is marginal at best. We have a 24 ft Maxum here with the same power and it always struggles to plane even with a clean bottom.
 
Sure wish you would have read and given us information in the 'sticky' thread above.

A 5.0 with BIII should run OK. Just remember, it's the smallest engine offered for your size boat.

Could be you got water in the engine by way of the exhaust. The 240 sits a little low in the water, especially with a big load. There is SO much we don't know You and this boat and how you run it and SOOOOOO much more.

Gotta do a comp test and complete tune-up. You gotta spend some time with the boat before taking it out on an 'outing'

Does 'shake-down cruise' bring up any ideas? Get a service/owners manual and do some studying.
 
quote:

Originally posted by adru

My tach will sometimes read over a 1000 rpm over where it should be, all it takes is a tap or two on the crystal and it falls back to the correct rpm reading.






Mine did that on my previous boat. Loosening the "U" bracket that held it to the dash cured the problem. Make it just tight enough to not move. I'm assuming it was originally installed tight enough to distort the case.
 
There was no wind, tops down, bottom is perfectly clean. It sounds like I am expecting too much out of the boat and I am on the edge of being under powered. I did not know if there was something to look for, like wrong props or something along those lines. kind of like "hey stupid, did you check the.... which would cause your exact problem" But it sounds like the general agreement is overloading and under power. Thanks.

Sorry if i did not put this in the correct forum... i thought this was sort of a general question and thats what this forum was for?
 
This is what Charlie was wanting you to read.......http://www.boatered.com/forum/topic.asp?TOPIC_ID=102991
 
When our '05 Rinker FV250 (350mag) was in its third season we started to have the same issues as you. The local yard looked at it and found the distributer cap somewhat corroded so they replaced it. It ran better but still wasn't quite right. I had them back again and they found 2 of the plugs were fowled so they replaced them all and it was right back running 5100 again and with power.

What props do you have? My Rinker ran well on 22's. If you have 24's I would question that, 20's would give you more pop out of the hole.

Good luck
Niles
 
its got 22's on it... i did not want to go for new props if it was a more serious problem... like putting a band-aid on a broken leg kinda thing.

what do you mean by "2 of the plugs were fowled". Do you mean they were dirty? Not firing? That is a new context for that word for me....
 
Back
Top