Pulpit Issues

tagguy

Member
exMember
Joined
Jan 23, 2009
RO Number
31045
Messages
35
Extentending from the bow to the end of the pulpit are 6 pieces of wood that are covered with water while the boat is dry docked . There has been an intrusion of water from this that has puddeled in the front compartment of the v-berth . I recently called the previous owner and he advised me that it doesnt hold water when shes in the water .The angle at which the boat was blocked was was causing this he instructed . Could it be that simple ? Or is this a problem associated with pulpits of this kind or with Luhrs any help as always is appreciated . On another note my deck is on reinforced and is looking like a 2008 Viking thanks to Freddy! anyone in South Jersey needing fiberglass work done HE is the man !
 
In order for you to get any kind of meaningful response to your questions, you need to be much more specific as to the exact problem.

I would include year and make of the boat, whether or not it was surveyed prior to purchase, what did the fiberglass work have to do with the problem, can you see any areas where water might be entering the hull, does it have a windlass, condition of the hawse pipe, etc., etc., etc.?

I personally don't buy the notion that water does not enter the pulpit area when the boat is moored but does when it is dry docked.

Bob
 
Blocking may be part of the problem, but regardless of how the boat is blocked, the water shouldn't leak through into the cabin. That also means it's going through the deck bolt holes and whatever other penetrations are in the vicinity, possibly causing rot and soaking the deck core. I'd investigate further. BEST case scenario, remove the offending parts and seal underneath them to stop the leak. Worst case, repair serious rot and deck damage ($$$).
 
post some pictures, I dont' really understand the 6 pieces of wood part... are you talking about a teak covered pulpit?

in any case, water shoudl not come in regardless of angle, unless maybe it's coming in where the rode goes into the locker. But then the locker shoudl be watertight and self draining over board.

If you indeed have a teak covered pulpit, maybe the teak was screwed and the holes where not sealed properly.

best thing to do is use a hose, wetting small areas at a time and watching when the water starts coming in.
 
...and re-do your spelling so it's more understandable.
 
quote:

Originally posted by jtybt15

...and re-do your spelling so it's more understandable.





Your a big help Charlie, I had no problem understanding his message.
Bill
 
Reply with Quote tagguy
The deck was cut for the installation of a new fuel tank . The tank and hoses have now been replaced and the deck will be put back on with a new non-skid surface sprayed on(same as Viking uses). My question is there anything I should look for during this process to make sure I'm getting my monies worth. I know due to the cold it will take 18-24 hours for the new fiberglass to kick but should I ask the fiberglass guy to do anything special. Freddy (from Viking) is doing the fiberglass repair - anyone know of him or have had work done by him?) . I' ve seen his work on older boats , its incredible . My total for the entire job is $9000.. Does that sound right ? I bought the boat for $21,000. and the motors are impeccable at least from the surveyors point of view. Bob Duane was the surveyor . the boat in question is 92 Luhrs 3420 motoryacht . Any advice would be helpful

Tagguy I assume this repair work was nowhere near the current puddling/leak?
Bill
 
Tagguy, take a deep breath and start over. a little better explaination/description will help. skip anything not related. and as stated, pic help
 
Sorry for the bad post will take pictures and go from there .
 
Back
Top