Removing the Cap Over the Door of Our 350 Mariner

G

gratcho

Member
Joined
Sep 6, 2008
RO Number
30715
Messages
76
Advice please - we think we found the leak into the cabin, it seems the seal in the seam between the exterior cabin walls and the the cap over the sliding door on our Mariner need to be redone. (The small roof behind the rear seat on the fly bridge) We took off all molding strips, got out as much of the sealant (caulk?) as possible, and removed a bunch of screws around the parimeter. We could separate the top from the sides over the door, but cannot separate the top from the back of the rear seat on the flybridge. Any advice? Should I call Carver to find out how the heck it is assembled so I can dis-assemble it?

Any advice is very welcome.

On the bright side, we got to go work on the boat...
 
Gratcho...I've never had one of these off, so I can't help you. Although, I think there may be some bolts or screws under the headliner in the entry area. I would give Carver a call and see what they can tell you.
 
You must log in or register to reply here.
Back
Top