rotor busted, normal?

daviddquillin

Member
Joined
Aug 18, 2005
RO Number
18757
Messages
33
Running down the bay, all systems normal, steady speed, and after about 15 minutes the engine suddenly shuts down and won't restart. Left me sitting dead in the water, 35 degrees out in 30 knot winds for two hours till I could get a tow. Turns out the rotor busted into a bunch of pieces. I have never heard of this happening, but now I will be nervous getting back on the water wondering if that was the symptom, and some underlying cause will make it happen again... anybody else have this happen? Crusader gas engine...
 
I've replaced Distributors after it happend.
I think (Personal opinion) that the shaft in the Distributor came up, bounced, wobbled, ect. I dont think the rotor busted and then was ground to bits.
Replace the distributor and cap.

After wards, with a timing light, watch the mark as you change rpm's a bit and see if the mark responds and stays steady. You may have a leaping timing chain or bad gears causing this as well.
 
Need info on your engine systems and year. Could be what thud said and even worn bushing in dist or hold down clamp got loose or......
 
You don't say what brand engines but don't some Mercruisers require some kind of adhesive for rotor install? If you move the internal dist. shaft up & down or side to side is there any wiggle at all? Prior to the shut down did you notice any screeching that could have been seizing dist. shaft bearing? Was it worked on recently-parts replaced?
 
A good arguement to carry a spare rotor (or even distributer) I used to keep a spare distributer on board, when I had single screw gas power boats.
 
David...I've never heard of it happening on a Crusade like yours, but I have heard of it on Mercruisers when people don't use the locktite that Sandy described
 
Defective or badly worn distributor bushing will cause excessive rotor shaft wobble. This can result in the rotor striking the distributor cap posts resulting in a damaged rotor and cap plus debris in the distributor inner parts. This condition is frequently seen when running at high RPM or when timing is off just a few degrees.

The answer is a new distributor. I prefer a competion marine aftermarket replacement from someone like Accel (sp?). Proper setup during installation is critical for best performance and longevity.
 
Even if the rotor grenaded, the 2 hold down screws should be secure and some remains of the rotor underneath them. If that is the case, and the cap screws are/were tight (cap in correct position too), then check for worn/damaged distributor. If the screws are loose on the rotor or cap, problem is there.
As far as loose hold down clamp on the distributor, that will not cause the rotor to shatter. Timing can change, but rotor can't hit the cap.

Ken
 
it happens pretty often as the distributer shaft bushing wears out allowing the shaft to move upward till something hits we replace with delco est dist they are better than performance as there are no advance weights to rust up
 
Another thing that can stress the whole inside of the distributor is a Back fire.

If the Crank stops, the Timing gear stops, the Distributor is still in motion. The Shaft rides up the Hypoid gear teeth on the camshaft. That can pop that Distributor shaft up with a lot of force.
That one backfire could dislodg the rotor aginst that spring in the Cap. The Rotor may not come back down all the way and eventually some part of it gives up and the rest is an unsolvable puzzle.
 
thud don,t forget on chevy based engines the dist drives the oil pump so there is a constant upward force on the dist thrust bearing
 
That is a lot of great information, thanks so much to all who answered! A lot of the boating experience depends on your confidence level in not being left stranded in the water... based on your comments for a single-screw boat like mine I think that means carrying a spare distributor...
 
Back
Top