Spring Projects

32carv

Well-known member
Member
Joined
Nov 4, 2006
RO Number
24150
Messages
1,309
I am getting my shopping list ready for my spring projects to be done before the boat is launched.

1) Install new Shakespeare TV Antenna and mount new flat screen TV.

2) Touch up bottom paint.

3) Remove and replace pinstripe decal at waterline.

4) Replace curtains in salon.

5) Replace carpet in salon.

What spring pojects are you planning?
 
I am going to do an air exchange project. Currently, both the cooler and fuel tank are largely full of air. Plan to exchange the air with beer and gasoline, respectively.
 
Install new combiner on my direct connect cellular amplifier and Digital antenna so I can run AT&T through my W-25 for phone and UMTS data and Sprint EVDO data.
Repair and new Gel coat the cockpit area.
Remove my Vacu-Flush to try the new Raritan Elegance head.
Install 2 new 120 degree sector antennas on the Marinas WiFi system.
Install Garmins new Auto Pilot and integrate with my Garmin Network.
Install an AIS Class B system and integrate it with my Garmin network.
Thats it unless Garmin releases their new NEMA2000 VHF radio then it will replace my Raymarine VHF radio.

Guess who's navigation electronics I love?
Bill
 
Install new risers and manifolds on both motors....
Change out dripless seals on both shafts....
Upgrade both TV's to flat screens.....
 
Pour Guiness in Glass
Lift Glass to lips an drink
Repeat as needed

Then paint the bottom and the trailer
 
Fill cooler with beer and ice, empty beer out of cooler, refill as necessary...
 
Double D you have any particular brand and wall assembly in mind? OR do you even need a new wall assembly since Tvs are already there?

My 10 projects are as follows:
1)New fresh water pump for cabin
going with Shurflo extreme smart sensor 4.0

2) New hot water heater
Going with Attwood 6 gal

3)Install already purchased Dual MXCP66 head unit for stereo up on deck

4) Install flat screen
Not sure who I am going with on this one

5) Install inverter
Not sure who i am going with on this one

6)fix transom shower

7) If I get lucky new windlass Lewmar 700 series

8) New shift cables
(one is bad but if snaking them I might as well replace both)

9) Thinking about replacing the port carb. It was rebuilt but it is giving me intermittent problems.

10) New cold beer to install all these things.
 
I have a few different ideas......maybe a 15" LCD/DVD in the master berth.....and a 19" LCD/DVD in the salon. No particular brands yet.. I'm thinking of having a local marine plastic shop make up something to cover the old TV hole.....to mount the new TV mount bracket to.....with maybe a pocket for the remotes.......or something like that.
 
Clean up the inside from all my winter projects.
Wash and wax the topsides.
Install new depth finder display.
The fridge is already full of beer and the tank is full of gas.
 
Things to do:
1. Media blast hull and repaint with ablative paint using a 'signal' coat, to avoid yearly painting.
2. Replace salon and 2nd bedroom TV with flatscreen and building cabinet.
3. Replace front bridge eisenglass utilizing Makrolon AR polycarbonate.
4. Replacing all zippers on canvas and eisenglass with heavier strength #10's.
5. Replacing cockpit carpet.
6. Replacing windshield dodger cover.
7. Having props scanned
 
Adding 46" plasma tv to cabinet behind helm seat. It will rise up out of the cabinet, then lower into a waterproof seal. Surround sound for the aft deck.
 
Bumming a ride with Hogan and....

The short list is:

New sound system with transom control
New trim tabs
Clean and double check wiring system (she's not a spring chicken anymore)
Replace gauges
A way of making the center windshield glass removable for easy access to bow camper-like enclosure

I'm going ask for some ideas here on the last item in a new thread.

Stan
 
Rewire cabin and install modular fuse panel.
Replace aft and mid bilge pumps.
Wire in and install windlass. Glass in anchor locker.
Install new Jabsco manual head.
 
quote:

Originally posted by lil red truck

Rewire cabin and install modular fuse panel.
Replace aft and mid bilge pumps.
Wire in and install windlass. Glass in anchor locker.
Install new Jabsco manual head.






If your running wire anyway, why not install an electric head?

Which brings me to my list

Replace existing head

Replace stereo system

Add under gunnel lighting

Add lighting to hardtop
 
Jason I highly recommend the Jensen LCD TV, most are if not all are HDTV ready and up to 23" you can run them on 12VDC, they run well all the way down to 10.8 volts. The circuit boards are conformal coated so moisture will not effect their operation or give them a premature death.
Bill
 
I replaced all my black water hoses and found out my aluminum holding tank was leaking. When we pulled the tank there was about a 1" layer of yellow cake. Lots of bleach, sanitized that area of the bilge then cleaned and repainted it. I also installed a charcoal filter on the waste tank this made a huge difference when we would 1st open the boat after a few hot closed up days! I also got rid of seawater and went with a fresh water head this eliminates critter smell in the rim of the head.
Bill
 
Back
Top