Stepped hulls

rjr

Member
Joined
Jul 25, 2002
RO Number
9498
Messages
66
I have a pretty bad case of twofootitus and am wondering about the increased efficiency of stepped hulls. The only time I was ever on one it felt odd in turns. Sort of skipped around corners. The only pictures I have seen of flipped boats were stepped hulls. Not many manufactures of cruising boats make them which says something, but a 6 - 7% increase in efficiency is pretty significant in the land of $4.00 gas. Comments?

rjr
 
I don't see any reference to what you have now, so I have no idea what size 2' more could be. However, I love my Regal 2660 (now 2765) with a very deep stepped hull. Regal called it FasTrac.

Yes, it does take a bit of getting used to, as the stern will slip a bit in a hard turn. I have never felt, though, that I was ever in any danger of flipping over, and this is a relatively tall boat. At 6100# dry; likely 7500# totally loaded and filled, I still get 1.5 mpg with twin 4.3's.

Only drawback I have is that any in-hull transducers have to be forward of the step, and that portion of the hull is barely wetted at speed.
 
I have a 28' Bayliner Flybridge. The other reason I want to get rid of it is that it pounds over 2' chop, which is all too typical in Long Is Sound. How is the ride in your Regal?

rjr
 
rjr Do you have trim tabs? I had that problem in my boat. After I had the Bennetts installed, my boats handles chop much much better!
 
Rides just fine in anything less that 3'; anything more and the Admiral screams at me!
 
My first boat was 21ft. regal with a stepped hull. Yes it would sometimes skip on sharp turns but I couldnt be happier running 54mph WOT with a 4.3L V6!
 
My 2001 Regal 2660/2765 has a stepped hull and I love it. It will run circles around the Four-Winns, S. Ray and Cruiser near me that are the same size but all have larger engines. Once the boat reaches plane and the stern rises up on the step hull the ride is great.

I have never had a problem with sharp turns and the skipping but it is rare to swing a 30' cruiser into a very sharp high speed turn.
 
In a performance hull I am not a fan of stepped hulls however in a cruiser I don't think it is a big issue because the speed is much less. However I do doubt the 7% efficiency claim. IMO there may be an advantage in water that is flatter then a book keepers butt however once you get into some good chop the hull will loosen up anyway.
 
Back
Top