Electrical Issues Help

bsteven43

Member
Joined
Sep 26, 2007
RO Number
28678
Messages
76
Guys - got a call yesteday from the marina to move my boat in preparation for haul out (2003 280 Sundancer). Hadn't been there in about 3 weeks. Went down and found the boat had no power to start the engines. Last time I was at the boat (3 weeks ago), I disconnected shore power and took the cord with me. Figured I wouldn't need it. I'm puzzled because a) I had very little on in the boat that will kill the batteries and b) had the battery selector switch turned to "1" (have either "1", "2" or "both" and a separate "on" "off" selector for the house battery.

So, first and foremost, to start the boat, will plugging in shore power get me back up and running? Will I need to leave it plugged in for a while to charge the batteries or will the boat start off shore power?

Any ideas why all my batteries were dead? I switch the selector to "2" and "both" and used the manual override jumper at the helm and had no power whatsoever.

It's been somewhat cold here, but not terribly cold. Just lack of use?

Also, will shore power constantly charge my batteries when plugged in? I have a "AC converter" rocker switch in the 120V section of my panel - what does that do?

Thanks for the help guys - got to get the boat started tomorrow.
 
a) but apparently, you had enough.
b) I have no idea what is connected to your battery switch, either "1" or "2". This makes it more difficult to respond.

Uh, no. The boat won't start off of shore power. You need to charge a good battery and start from that.

I assume that the "manual override jumper at the helm" refers to a battery parallel switch, but if you have no power the solenoid will not work ( or if it does and both batteries are dead, same result ).

"will shore power constantly charge my batteries when plugged in? I have a "AC converter" rocker switch in the 120V section of my panel - what does that do? "

Depends what runs off of shore power. If your "AC converter" is a charger, then it will try to charge your batteries, if not, then no it won't. I suspect that the "AC converter" is an inverter. It may also contain a charger. With the model num and mfgr we can tell you more, or try to find the manual...

--

Forgive me for stating the obvious: I haven't read the manual on your boat's equipment. The manual(s) will answer these questions.

--

Have you used a handheld ( not panel ) voltmeter to measure battery voltage? Your description falls short of providing enough info to know how many batteries you have, but test them all. Test specific gravity as well, while you are there.

In any event, since you absolutely have to get the boat started tomorrow, stop by the friendly battery place and buy a new battery, bring it to the boat and replace one of the onboard batteries, then adjust the switches so that the new one is active. Then you can start the boat. If you let us ave a bit more info, we will try to give better answers. Good luck with the fresh battery!
 
Certainly agree with Bill, and every boater needs to have a digital volt meter in his tool kit. If you are leaving the boat, it is best to turn off all of the batteries. The bilge pump should be hard wired to one of the batteries.

Things which run down batteries. Often the memory in the radio. Next is some electronics left on, then some light left on. Also a leek, or heavy rain, causing the bilge pump to run much of the time and draining the battery.

Your batteries being flat, suggest that there is at least some damage to them. Batteries will tolerate being fully discharged only to a degree. If it happens only once and you get them charged back up, they should be OK--but I would be considering replacement next season--or at least re-conditioning them during the off season.

People need to know about their boats. What size of battery charger do you have. Is it turned on? (there should be a switch on the 110 V pannel labled "battery charger". I have high quality battery chargers and I leave them on. But you need to know what voltage the battery charger floats the battery at. If the voltage is too high, water will boil off and the battery will be damaged (you may have had this happen also--and the charger was keeping the batteries up--and you didn't know that you had damage) when was the last time you checked the electrolyte level in the batteries?

The AC converter it is probably an inverter--which changes 12 volts DC to 120 volts AC (incidently if the inverter is left on, this is also a current draw on the battery--I have a "on off" switch on mine, and it is off, unless I am using that circuit on the boat. This avoids the battery draw down.

RV's have a DC converter--which is usually 30 to 50 amps--and provides 12 volts DC at 13.7 or so volts, to run the appliances in the RV--for the most part boats have larger battery banks, and use a marine battery charger--anywhere from 5 to 50 or so amps--some inverters have a built in charger up to 200 amps--but this is for big battery banks)

If you have a 10 amp battery charger on the engine start battery, it will charge at no more than 10 amps an hour. The average gas engine starts with a 100 amp hour battery, so it will take 10 hours or more to charge. I personally don't like to use a "jump start" set for a boat--since this is not spark protected and has potential risk of a spark--and explosion on a gas powered boat.

Good luck--and pick up that new battery and put it on a charager at home tonight.
 
I am assuming the refigerator was turned off. Since both batteries were dead, and you shut down batt #2, I will assume the draw came from a direct fed line. A common draw that will kill both batteries are the carbon monoxide sensors. These cycle every few minutes...non stop. Next would be the obvious, bilge pumps, shower sump, and radio memory.

Good Luck
 
quote:

Originally posted by Kellyg

I am assuming the refigerator was turned off. Since both batteries were dead, and you shut down batt #2, I will assume the draw came from a direct fed line. A common draw that will kill both batteries are the carbon monoxide sensors. These cycle every few minutes...non stop. Next would be the obvious, bilge pumps, shower sump, and radio memory.

Good Luck






Gary - I never thought of the CO detector ... I really didn't understand why both batteries were dead but the direct line to the 2nd battery is probably the culprit Assuming I can get the boat started tomorrow, how long will I need to run it to properly recharge the batteries? Will both batteries recharge off the engines automatically regardless of the switch selection i.e 1, 2, or both? Thanks for the help.
 
It could be a combination of the radio memory, CO-2 detector, bilge pumps and any anti corrosion device you have to protect your out drive. These devices could put a drain on a less than idea battery setup over the period you indicated.

I use one of those jump start battery packs with the jumper cables when I visit the boat in the winter, just to give me some lights and music.

In Aug, my boat experienced a lightening storm which fried my battery charger. The fridge eventually drained my batteries and I had not driven the boat enough to fully charge my batteries – the result is after a week or so my batteries had nothing left. That’s when the yellow self contained batter jumper came in. Well worth the $40.
 
"Assuming I can get the boat started tomorrow, how long will I need to run it to properly recharge the batteries? Will both batteries recharge off the engines automatically regardless of the switch selection i.e 1, 2, or both?"

Whether it will charge one or both it really determined by how your particular is rigged ( often, by the dealer, and not necessarilly the same as other similar boats ). This is something you should find out, however...

as far as charging time, this will vary with engine speed, alternator capacity, and battery size ( ie: not enough info. Sorry ) But you can figure that at cruise speed, you will put about 30 amps per hour into the battery(ies). Batteries hold in the neighborhood of 100Amps ( this also can vary, widely, based on type, size, age and condition ). Since they are both apparently dead, I would reccomend that each get one 24hr charge cycle from a 10A 3-stage charger. If the batteries have not been damaged ( unknown at this point ) that should fully charge each battery. But I have reservations as to whether or not the batteries are reliable. It could take a couple of days to fully check them out ( ie: charge them, then wait while they sit, unattached, to see if they hold a full charge 24 hrs ).

If you need to move the boat to a winter berth or haul out, I would spring for a less than $100 battery from NAPA, WalMart etc to make the trip and then deal with the batteries when you have the time to do it right. The time frame makes things more difficult.
 
Back
Top