Hatch Replacement

K Weaver

Member
Member
Joined
Mar 19, 2006
RO Number
20552
Messages
21
My hatch was leaking last year during heavy rains so this winer I removed the hatch and cleaned the fiberglass and aluminum on the hatch. I am ready to replace the hatch and was looking for any tips are tricks.
 
That's a '96 27" Rinker, right? You have the old hatch off and are ready to install a new OEM or aftermarket hatch?
 
"I removed the hatch and cleaned the fiberglass and aluminum on the hatch."

Looks like he's gonna use the same one.
 
Was using the same hatch, nothing wrong, just the seal was leaking under heavey rain.
 
If a gasket is involved with this deck hatch it's best to replace it. If bedding compound (caulk) was used during installation I recommend using something like Sikaflex. I've had good luck with it. Stays flexible but long lived. 3M 5200 is too permanent, silicon tends to chunk. Dry fit first and use blue masking tape along edges. Use plenty of sealant so a little surplus squeezes out along all of the edges during install. Squeegee off any surplus with an epoxy spreader or damp paper towel. Then remove the tape.
 
When mine leaked, I just tightened all the screws all around. That fixed the problem. The screws on the fore side were all very loose. No more leaks. Now I check them once or twice a year.
 
Thanks,
Like the idea of the blue masking tape. I have a tendency to be a little sloppy with caulking, this should help.
 
Back
Top