My hatch was leaking last year during heavy rains so this winer I removed the hatch and cleaned the fiberglass and aluminum on the hatch. I am ready to replace the hatch and was looking for any tips are tricks.
If a gasket is involved with this deck hatch it's best to replace it. If bedding compound (caulk) was used during installation I recommend using something like Sikaflex. I've had good luck with it. Stays flexible but long lived. 3M 5200 is too permanent, silicon tends to chunk. Dry fit first and use blue masking tape along edges. Use plenty of sealant so a little surplus squeezes out along all of the edges during install. Squeegee off any surplus with an epoxy spreader or damp paper towel. Then remove the tape.
When mine leaked, I just tightened all the screws all around. That fixed the problem. The screws on the fore side were all very loose. No more leaks. Now I check them once or twice a year.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.