I posted this in another forum, but probably should have here instead. I have a Jabsco 37*** series that worked for one flush (bowl full of stagnet water from sitting for a few weeks) then would not flush any more. I moved the shaft around a bit, it flushed again, then back to not working and tripping the breaker again. I disassembled the pump and apart it works fine. Re-assembled, back to not working. So...is it just in need of the service kit, or is it a bad pump?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Messed up in the head...
- Thread starter TheBobman
- Start date
- Joined
- Mar 5, 2001
- RO Number
- 3655
- Messages
- 1,800
Sounds to me like a shorted motor.
- Joined
- Mar 5, 2001
- RO Number
- 3655
- Messages
- 1,800
Not necessarily - it depends on how much juice the motor is drawing. Another possibility is bad or dry motor bearing, causing an undue load on the motor.